Jim Bowen 1 Posted June 20, 2013 Just something people may want to check out. I fitted that bonnet foam from the group buy, its been on since about December 2012 and has been fine. But with the hot weather we had yesterday, i happened to notice when lifting the bonnet that all the glue holding it on had softened and three of the bits had mostly come off and just hanging down onto the engine :lol: Which was nice! Quote Share this post Link to post Share on other sites
g0ldf1ng3r 14 Posted June 20, 2013 which glue did you use to hold the new stuff on jim? & any recommendations or hints about how you removed your old stuff......im hoping to do mine in the next few weeks :) Quote Share this post Link to post Share on other sites
Jim Bowen 1 Posted June 20, 2013 I used the glue it said to use on the instructions and took a while to find a place that sold it as well. Think it was 3M #80 Spray adhesive. I just used white spirits to remove the old glue, once you have pulled the foam off you have a layer of glue, i just spent a while softening it with white spirts then scraping it off with a credit card or plastic ice scraper. Takes quite a bit of time, but cleans up like new. Quote Share this post Link to post Share on other sites
Kevin Bacon 5 Posted June 20, 2013 White spirits? Girl :D Crack open the manly glue thinners and do it in a tenth of the time! Trouble is, it's difficult buying chemicals these days because of all the junkie glue sniffers. Quote Share this post Link to post Share on other sites
g0ldf1ng3r 14 Posted June 21, 2013 Trouble is, it's difficult buying chemicals these days because of all the junkie glue sniffers. Thanks Jim & Kev - always appreciate your input :D & kev you crack me up once again lol Quote Share this post Link to post Share on other sites
cdem 0 Posted June 22, 2013 If I remember right I used SG sticky stuff remover on mine, worked a treat :-) Quote Share this post Link to post Share on other sites
