Tigerfish 10 Posted May 7, 2014 Getting the car ready for its MOT with various bits of work. Water leak fixed, Lambda VAGCOM error cleared up, NS rear caliper changed, 288 front brake upgrade with new discs and pads, handbrake sorted. Last thing that has cropped up is a stored code for 00561, Mixture Adaptation - Static adaptation limit (add) not succeeded. I'm assuming this is likely to cause an emissions failure? I also seem to have a bit of a stutter on accelartion when taking a rigth hand bend at anything other than a crawl. Would both of these (stutter and error code) point towards a leak on the intake side? I gather there are a few possibilities, but the cornering stutter would make me think that the engive shift on the cornering is flexing the intake a bit and causing a leak (even though I can't find anything obvious). any one else had a similar thing? Quote Share this post Link to post Share on other sites
Supercharged 2 Posted May 7, 2014 Things to look at - air leaks as you say, TB allignment, TPS, MAF and Lambda Quote Share this post Link to post Share on other sites
Tigerfish 10 Posted May 8, 2014 OK, thanks. I'll start with the air leak and work my way up. Quote Share this post Link to post Share on other sites
Mawrick 0 Posted May 9, 2014 Here is the tips from Ross-tech on this failure code: 00561 - Mixture Adaptation 00561 - Mixture Adaptation: Adaptation Limit (Add) Exceeded Possible Symptoms Engine Jolting Increased Fuel Consumption Poor Idling/Jolting Reduced Boost Pressure Possible Causes Mass Air Flow Sensor (G70) faulty Fuel Pressure too Low Leaks in Intake Air System and/or Exhaust System Injector(s) faulty (i.e. coked) Possible Solutions Refuel Vehicle Check Fuel System Pressure Check Mass Air Flow Sensor (G70) Check Intake Air System and Exhaust System for Leaks Check Injection Quantity Check Injector(s) Quote Share this post Link to post Share on other sites
