Mrbaldhead

oohh £300+ for a new MAF :(

Oh fantastic, do you have any pictures i.e. is it in good nick and not 10 years old? Thanks Buddy

I had a problem with my ISV about 8 weeks back where the engine just cut out whilst i was driving and on start up the idle was all over the shop. RAC came to tow me home but after a bit of poking and taking sensors in and out on the VAG-COM it was mysteriously fixed. I was going to take the ISV off and give it a good clean but there have been no issues since so i'm not going to fix what is not broken. However, noticed the MAF connector wires were nearly snapped so sourced another plug, snipped the old one off and neatly soldered a new one on, covered the wires in heat shield and job done. Happy as larry no issues what so ever. Yes you guessed....... There is a nibbling problem in that when the weather is wet or cold and the engine has not come up to temp, the car is quite juddery. There are no idle isues just when I keep a constant idle in say 2nd gear at 3000 RMP, the car is very fidgity and lumpy. As soon as the car is up to temp the issue goes 100%. Yet it seems that the car is a bit down on power? Does anyone have any ideas? I mean I need a new air filter as the KnN is a tad thick and I use 5W-40 Castrol oil with MOMENTUM 99 fuel. Anyone else have any similar issues? Thanks Ian :)

Does anyone have a BMC CDA induction kit lying arround?? Ian

AHH these are so nice and exactly what I am after...... Just have to sell my 17" BBS RX's before hand :(

Someone.... anyone

I'm still on the hunt for a Badge-less Grill and Eye Brow for my VR6, as a bloody bird totalled the one I have. Seen a few for sale from new but seeing if anyone has one lying about? 07427602252 - Ian

'Transporter 3 slat vent plate, obviously never used and will need primed etc £20' Does this have an eye brow too? like this as need to replace mine due to a fricken bird!

JIM - anygood?? http://www.ebay.co.uk/itm/VW-Corrado-Storm-Leather-Steering-Wheel-Mk1-Mk2-Golf-Scirocco-Passat-Rare-/182105004046?hash=item2a664dd80e:g:VkwAAOSw6oBXE7It

Does anyone have any ideas of any large corrado meets? I'm from the Reading area and was thinking when the weather improves does anyone fancy having a large gathering and go on a cruise followed by some pub grub?

Anything free goes fast!

Want to PM me your address and can send it tomorrow?

Original steering wheel from my VR6. Its in okay condition, pictures highlight the issues. - Pealing and light cracking at the top - Wear on Right side by hand position - Seem split on part of inside. - No centre cap for the horn. Looking at it in the drivers seat, it is passable but needs to go as stuck in my room now... Just need the money to cover postage but if you collect then its FREE.

Anyone found one hiding at the back of a garage etc? If not a new one it is

Today a bloody bird smashed my front grill to bits, does anyone have a badge-less grill and eyebrow for sale? Depending on location i can collect as i know they are quite long to post. Just my bloody luck :(

It was me!! It was looking smart until a bloody bird flew through my grill on the way back :( Need to source a new badgeless Eyebrow and grill now in Black.

How much do you want? I can come and pick up

Thanks guys! Yes its Diamond Black, still amazed at how it polishes up for a near 20 YO car :)

A few pictures of the beast!

Thanks for all the help guys, very much appreciated! This forum and users always put the effort to help everyone out, fantastic to be a part of this world :)

Where the heck will I find 4 new female pins??

So i assume you push that tool down the connector end and the wire and pin slot out? Is this a tricky job, or will that tool make it light work? Thanks

Had some issues with my MAF plug as the original wires have split, So I need a new plug to chop the old one off and solder on a new one. Pictures show the state of mine....... :/

Sorry did not look back on here.... I will wait for the time being buddy, as have lots of other jobs to do before really. If it doesn't sell then pop me a message. Ian

Yes please, is it the 4 pin female. Need the wires attatched so can snip old one off and re connect the new one.