m3evo

Hi, I know just about everybody fits Bosche W5dpo plugs to their G60s, but has anybody thought of fitting the NGK equivalent? just wondered cheers Dave.

This is not a slagging off job but may be of some help to those with this type of mounting( has allready been mentioned in a previous thread a few weeks ago thank goodness which is what pointed me to the mounting problem) anyway ive just spent the last two days arguing the toss with the development guy at Milltek exhausts, stating the there is a problem with the De-cat pipe on my car, in as much that the Co-sensor is burried into my heat shield in the tunnel where the exhaust go from front to back so much that the wires have broken off the top of the sensor, now rightly Milltek stood there ground and denied that there is a problem with the de-cat pipe where the sensor goes, BECAUSE its the JMR solid front engine mounting thats 20mm too short and allowing the engine to tilt forward thus causing the co-sensor to come into contact with the tunnel, now new co-sensor needed at £90 and told to either fit a standard front mount or pack it up with a 20mm spacer great i thinks not, check your mountings and co-sensors cheers Dave

Hi Crasher, Its got a full Milltec system on her, standard cast manifold but really big twin down pipes and its just catching the subframe a bit, it was fitted by John Mitchell for the last owner been told there quite rare the large down pipes, thinks ill have to have a word with local garage then if not good idea on stands, where is the best place to buy a vibratecnics fron mount? Cheers Dave

Hi Thinking of replacing all three engine mountings on my G60, Its got a Solid front one. but would really prefer Vibratecnics or something similar i think its one of the dodgy ones front ones that was mentioned the other day, reason im wanting to replace especially the rears is theres a bit of a knock from the exhaust under excelleration, and the lamda wires were broke when i got the car, now fixed, what sort of a job is it difficult or not? what should i look out for? and is it possible to do off axle stands or do you need a garage lift? Thanks Dave

Looking for a Rallye intercooler, whats the going rate, they seem to vary an awfull lot, from quite reasonable to silly money, cheers Dave

Thanks Neil, and everybody else for the help and info, will check engine mountings etc, thanks again lads, Dave

Cheers Joe, Ill get on to it soon as poss, thanks again, Dave

Hi, Sorry forgot to say my car is a Corrado G60,cheers Dave

Hi, Hope the photo comes out ok, this is of some loose wires at the back of the engine, drivers side from a plug with four wires going to it, there are two that are loose one black and one purple colour, anybody know what there for, many thanks Dave

HI, Yes i noticed the leeds reg, im actually going to pick it up from the other end of the country its down near portsmouth now! Cheers Dave

Hi, Bit of a long shot this, but wondered if any body on the forum has owned this car or knows any history about it, ive just won it on ebay its looks ok but would be nice to hear from fellow corrado owners any info on it 91 g60 reg H491XUM ebay no- 4634877714 cheers Dave

Hi Bit of help needed, Corrado sunroof works in tilt position, but not in slide what is the usual problem? and is it easy to fix? and is it expensive to fix? Many thanks Dave