rgn

Hi, I need to check that they will fit the 9a engine, I assume the ones you have are from a 2e correct?

Hi, Do you have the 2 v belt pulleys that fit to the crank please? and are you willing to sell them? Many Thanks Richard

Hi, Are these still available please, and how much? Many Thanks

A big thank you to SuperCharged it was the ignitions switch. I've changed 3 of these on golfs before, but when these have always caused the car not to turn over, never to turn over but with no spark! PS a new swith from the dealers was £18 not too bad when a pirate copy was £11.50. Thanks again

Hi Guys, strange fault this one. When cranked there is no spark, but if I remove the distribitor and turn it by hand there is a good fat spark and the injectors fire etc. Put dibby back in and try starting and there is no spark! I took the dibby out to try and prove the ecu, dibby etc. Any Ideas please? what does the factory immobiliser doe? Thanks

Oil is Vw semi, and filter is genuine

Yep Oil level OK, was a bit low though

My Oil light is flashing! (2.0L 16v 9A). Have checked the two switches on the oil filter housing, and both are closing. Fitted oil gauge and it show 80psi. but not sure if gauge is correct. So I'm sure I have oil pressuer, but light is still on. Are there any other oil pressure swithes? Is the switch with the square connector, on the head, by the water flange, oil pressure or oil temp?

Thanks for all the advice guys. Looking format to hearing form davidwort when you have completed your scanning. Thanks again

I dont think that the 9a engine was fitted to the Golf/Vento so this manual wont cover the engine that I have, Thanks anyway

It's a 1995 2.0L 16v

Can any tell me which Haynes manual covers the 9A? Phoned Haynes and they say they don't do any manual that covers the 9A, but I know that peoplehere have mentioned the passat manual, I'n just not sure which one. Many Thanks

Phil, Any chance of a copy of the scan on how to set the mixture please? Many Thanks

Thanks for the reply, I will give v409 a try set the baud rate ,as I dont think I did this therefore would have been set to the default 0. If it still a problem, I will get a new cable. V3 did see the ABS controller tho!

Thanks for the replies guys. Nice to know it should work! Where, apart from RossTech, is the best place to get a cable, preferable USB?