87 Jetta 16v

I have a pair of classic green wings in good condition. However, unfortunately I am in Reading and I think they would probably be banana shaped by the time a courier gets hold of them. :(

I have one, I need to check to see if all three studs are intact, but from memory they are. I am away from home until Monday but can check then. I would be looking for £55 posted if that helps and all in good condition?

I have one, its seen a couple of speedbumps, but it's not too bad, no holes. Yours for £25 collected, or + £5 postage if that helps? Thanks, Neal.

Hi there, I have one in perfect working order. Yours for £30 posted if that helps?

Hmm, I have a set of FK Konigsport coilovers. They have done a couple of snowy winters and look as such, but the adjusters all move and the dampers still work perfectly. I would be looking for £250 + postage if that helps? I think they were about £700 new.

Hi Guys, I forgot to say that I am on holiday this week. I will get some pics asap on my return. Sorry, N.

I have a tornado red Jetta and a Corrado too :) I will try to get some pics up tomorrow night.

I have one in fairly good condition from memory. It's blackberry in colour. Yours for £30 + postage if that helps (unless you are passing Berkshire that is) Thanks, N.

Hi there, I have one in good working condition. Yours for £25 + postage (£10) if that helps? Thanks, N.

Hi there, I have one for a VR. Yours for £12 posted if that helps? Thanks, N.

Hi there, Unfortunately not good timing, I am away over the weekend, though I can be around on the Sunday evening if that helps? Thanks, Neal.

Hi there, I have a set in good condition. Yours for £20 collected from Reading / Bracknell if that helps? Thanks, N.

Hi there, This would indeed be direct fitment to the corrado block. The head is ported with three angle seats. Grant built a number of VR6 motors for the VW cup and some of the highest known output NA cars run his engines so with regard to the work done on the head, and engine building in general, he knew what he was doing.

Hi there, Apologies, I missed this, work has been pretty mental in the last week or so. It is a GMS head, it happens to be a late version (OBD2) with the larger oil draindown on the sprocket end, but both type are interchangeable. It was sold as part of a full engine conversion that I have the paperwork for. Unfortunately the rest of the engine was dead due to a cracked block. The engine had done circa 40k. Does that help at all? Thanks, Neal.

Hi there, I have a Grant Motorsport head that I am not using if that helps at all?

Hi Tim, Any luck with the above? Thanks, N.

Additional request Tim, do you also have the lower part of the tunnel cover with all of the fixings intact too? Thanks, N.

Hi Rob, I have a pair in black in good condition. Yours for £20 collected or £29 posted if that helps? Thanks, Neal.

Hi Tim, Yep, that sounds like the two items. The car is indeed a VR, so the ally lump with the plastic pulley bolted on...without grumbling or squeaks please, so if you turn by hand it should be nice and smooth, unlike mine that developed a fault while it wasn't even on the car, lol :)

Hi All, Continued issues this week are... Does anyone have a aux belt tensioner with a nice smooth silent bearing, and... The plastic trim that sits around the handbrake lever. Not the actual lever cover, but the surround that goes between the seats. Upper part only. Must have both fixing points intact, the one below the handbrake and the one underneath the rear ashtray. Thanks in advance for any help, Neal.

Hi there, Apologies for the delay, I haven't checked this thread since I last posted on it. Oops. Just found an appropriately sized box, these will be in the post to you tomorrow. Thanks and sorry for the delay. Neal.

Hi all, Some more items ending tonight in about 30 minutes time. 5 stud hubs, VR6 cat, downpipes, exhaust manifolds, some trim, badges, plus a few other pieces for gti and 16v models. Most are still 99p but please feel free to have a look and make a bid. There is no reserve so you could get a bargain. Thanks for looking, Neal. http://www.ebay.co.uk/sch/neal.humphries/m.html?_trksid=p4340.l2562

Hi there, I am in Reading / Bracknell, Berkshire if that helps? Thanks, N. ---------- Post added at 08:49 PM ---------- Previous post was at 08:48 PM ---------- A couple more parts listed tonight. I think the end of the clearance is in sight :) That said, I have just thought of some more parts in the boot of another of my cars. I'll post once I list them. The parts listed today are all 99p with no reserve so please feel free to take a look and have a bid. Lots of parts end on Sunday around 7 in the evening. http://www.ebay.co.uk/sch/neal.humphries/m.html?_trksid=p4340.l2562 Thanks for looking, Neal.

Hmm, I have a set of corrado ultra-violet recaros that I am contemplating selling if that is what you are looking for...

Some more items added. Badges, exhaust parts, suspension parts and a few pieces of trim. As always, 99p so please feel free to have a bid if there is anything that you need. Thanks for looking, Neal. http://shop.ebay.co.uk/neal.humphries/m.html?_trksid=p4340.l2562