fla 9 Posted April 21, 2008 Does anyone know what the flywheel bolt torques should be - there's no mention in Bentley? I'm guessing at least 100Nm.. These are the 8 or so bolts below the chains cover. For a VR btw. Thanks Quote Share this post Link to post Share on other sites
easypops 8 Posted April 21, 2008 found this on autodata, hope its of help, best let someone in the know confirm also :D Quote Share this post Link to post Share on other sites
H8RRA 0 Posted April 21, 2008 what a damn coincidence - i've just come out of the garage to check my bentley manual on cd for flywheel torque bolt settings.... bizarre Quote Share this post Link to post Share on other sites
fla 9 Posted April 21, 2008 Thanks for that guys. Its actually the centre 6 bolt holes as shown in H8rra's diag, where there arent any bolts (if that makes sense :cuckoo: ) I need to use these for the torque converter back plate, but i'm sure you manual transmission guys also use it to mount the flywheel? Quote Share this post Link to post Share on other sites
Supercharged 2 Posted April 21, 2008 Yeah - that 60Nm + 90 Degrees is correct and you must use new bolts (come with locking compound) There is a bulitin about this, apparently the original figures on G60's were 30Nm and the bolts were coming loose :shock: Quote Share this post Link to post Share on other sites
H8RRA 0 Posted April 21, 2008 Thanks for that guys. Its actually the centre 6 bolt holes as shown in H8rra's diag, where there arent any bolts (if that makes sense :cuckoo: ) I need to use these for the torque converter back plate, but i'm sure you manual transmission guys also use it to mount the flywheel? thats the 60nm bolts +90 DEG Quote Share this post Link to post Share on other sites
