Rear engine mount...how to replace it?

[MonkeyVR6 0]

Hi chaps,

 

So I've replaced the front engine mount today (well, my mate did!) and now I need to replace the rear one, I'm told its more complicated. Any tips?

 

Cheers.

[craigowl 0]

Make sure you get a new bolt for it - the original is "one-use-only" and they can shear quite easily on tightening to torque.

 

I had to go to garage after bolt sheared when I was retightening. Had been replacing water pump ( you raise engine on jack after loosening mounting bolts then retighten them.)

[mattwelcer 0]

Remember before tightening the mounts properly up start the engine a few times to let it settle in its "natural" position. Then tighten up the mounts to the correct torque value.

[craigowl 0]

:thumb right:

Hey! That sounds like a good one, Matt.

[MonkeyVR6 0]

Cheers for the tips lads, the new mount is in and all seem to be well. Next step >>> top mounts!!