Kempy 0 Posted September 27, 2011 keep up the lower dash bits? My car has shiny stainless screws which look terrible. What kinda pitch are the screws, I got a few spare ones but if anyone has got a pic of the correct ones that would be great, also what screws it into the dash at the bottom as I got stainless there to:crazyeyes: Quote Share this post Link to post Share on other sites
davidwort 0 Posted September 27, 2011 Very fine thread, more of a bolt than a screw thread, the ones holding the heater controls to the dash or the cover plastic where the rear seatbelts come out of the parcel shelf support are the same iirc Quote Share this post Link to post Share on other sites
Kempy 0 Posted September 27, 2011 i know the ones, cheers Quote Share this post Link to post Share on other sites
OllieVR6 0 Posted September 27, 2011 (edited) Last time I was in halfrauds (it was a while ago) they were selling 'trim' fixings in those little bubble pack things, unless you can still get them from the stealers? Edited September 27, 2011 by OllieVR6 Quote Share this post Link to post Share on other sites
dragon green 5 Posted September 28, 2011 Still available from the dealers, as there not Corrado specific ! I got some a few months ago,cheap as chips Quote Share this post Link to post Share on other sites
tony_ack 0 Posted September 28, 2011 They are the main type of screw used in the dash so they are usually the ones you have left at the end after changing the heater matrix Quote Share this post Link to post Share on other sites
