britpop95 0 Posted April 24, 2015 Just cos im exited, and after a 4 week wait my new purple samcos just arrived :-D Quote Share this post Link to post Share on other sites
Jim Bowen 1 Posted April 24, 2015 Try and use spring clamps on them rather than jubilee clips, the jubilees seem to slacken off after a while and then you keep tightening them up and they start cutting into the hoses. I do have a list of all the correct sizes you need from a place called HCL Clamping, i just need to type it up. Quote Share this post Link to post Share on other sites
britpop95 0 Posted April 24, 2015 Jim that would be great if you could get the sizes mate. Thanks for the tip. Quote Share this post Link to post Share on other sites
easypops 8 Posted April 24, 2015 I'd like to see that list too please Jim :) Quote Share this post Link to post Share on other sites
Jim Bowen 1 Posted April 24, 2015 I'll try do it over the weekend, i have it all written down but intended to put it on a diagram Quote Share this post Link to post Share on other sites
easypops 8 Posted April 24, 2015 That would be great mate, although I'm in no rush as mine is deffo a long term project:) Quote Share this post Link to post Share on other sites
Jamie 1 Posted April 25, 2015 I measured them all up and worked out the cost of buying the clamps individually - worked out cheaper to just buy Roose Motorsports kit in the end Quote Share this post Link to post Share on other sites
Jim Bowen 1 Posted April 25, 2015 Are the Roose ones just jubilee clips though? Quote Share this post Link to post Share on other sites
Jamie 1 Posted April 25, 2015 Are the Roose ones just jubilee clips though? No they're JCS Hi-Torques. They were recommended to me by pretty much everyone on here at the time, I was just trying to do it on the cheap Quote Share this post Link to post Share on other sites
