door locks and pins

[lion 0]

I need a bit of help. Both of my doors the door pins have been pulled out. How do I fit them back on. I have removed the door cards but see what the metal rods are ment to connect to

[Tigerfish 10]

I've got some rods arriving this week hopefully, so if no one has responded by then I will be fitting mine and can do some pics.

[davidwort 0]

there's a small plastic clip that the rod is inserted into at an angle, a tab or two breaks off it rendering it useless and the rod falls out

 

second image in the top post on p9: http://the-corrado.net/showthread.php?t=12282&page=9

Edited May 28, 2014 by davidwort

[lion 0]

They're the clips that are broken on mine. Anyone know where I can get 2 new ones

[robrado974 1]

Still avalible at tps . Around 75p each i think .

[g0ldf1ng3r 13]

Still avalible at tps . Around 75p each i think .

 

Ooo nice - i have this issue on the gf's storm drivers door

 

having attempted a fix & given up im a tad mistified how you would fit them tho lol

[lion 0]

Nice 1, dont suppose u have a part number, and is the passanger side and driverside the same?

[leon263 0]

Part numbers below, Google the part number for an image. It's a plastic clip which slides onto a lever to the back of the door latch mechanism, the rod then clips into the plastic clip.

 

 

357837083 ............ Left

 

357837084 ............ Right

Edited May 29, 2014 by leon263

[g0ldf1ng3r 13]

Part numbers below, Google the part number for an image. It's a plastic clip which slides onto a lever to the back of the door latch mechanism, the rod then clips into the plastic clip.

 

 

357837083 ............ Left

 

357837084 ............ Right

 

winner thank you kindly leaon263!

[lion 0]

Thanks very much

[lion 0]

Given tps a call and ordered the right side, but the left side is obsolete, anybody know where else I can look for 1.

Thanks

[davidwort 0]

another candidate for 3D printing I reckon

[Jim 1]

another candidate for 3D printing I reckon

 

If only I could get the first project actually moving.. :|

[j_s14a 0]

Mine was broken on the drivers side, so I placed the rod in the correct location, and used two small cable ties tho hold them together. Still works perfectly. :) You'll need to remove the doorcard to get to it, but I would also recommend removing the door handle too, makes it easier. :)