Kempy 0 Posted September 2, 2014 Hello I'm sure the temps are fine but the reading on the clocks is hovering around 70deg Where is the sensor,is it on the reservoir? Or is that just the level sensor thanks again Quote Share this post Link to post Share on other sites
lesarcsneil 0 Posted September 4, 2014 The coolant temperature sensors are screwed into the cylinder head near to the distributor, this thread should help: http://the-corrado.net/showthread.php?t=84896 Neil Quote Share this post Link to post Share on other sites
Jim 2 Posted September 4, 2014 I believe this could also be a symptom of your thermostat being stuck open possibly? The reservoir sensor is indeed just a level sensor. Quote Share this post Link to post Share on other sites
Liam20vT 10 Posted September 4, 2014 My rado always sit's at around 70c with normal driving, even with a new sensor! I just let it be to be honest, Hasnt caused me any issues in 1.5 years! Quote Share this post Link to post Share on other sites
davidwort 0 Posted September 4, 2014 (edited) swap the wires around as there's more than one identical water temp sensor, gauge, ignition ECU and idle control, that way you can see if all the sensors read the same, if they do and it's a stat problem then the car should get up to 90 degrees stationary but drop lower as you drive and airflow cools the rad. thinking about it, the 9A may not have several of the single pole black top small water temp sensors, in which case all you can do is inspect the wiring near the connection and try a new sensor Edited September 4, 2014 by davidwort Quote Share this post Link to post Share on other sites
