Anyone cutting up a shell?

[Jim Bowen 1]

After some bits of corrado if anyone can help?

 

Was in touch with a guy on ebay, but at the last minute i'm not too sure about the seller.

[lilfuzzer 1]

Hi jim I will be in a month or so what you after?

[dickie 0]

I've got one, what are you after?

[Jim Bowen 1]

Great. I will get the pics up. It's the drivers rear corner of car. Where the two bumper mounts sit.

and the drivers side bottom of a pillar where it meets the sill.

 

Have got some photos on work pc

[dickie 0]

No worries, I'll make sure the bits are solid when I get pictures

[Jim Bowen 1]

Some pics

 

First bit is only little, but would save me some work and finding some metal

 

Then the most needed bit is the drivers side rear, under the bumper, its where the two round mounts sit.

 

^^need as much of it as possible really, i also might need some bits from under the car,

 

And then drivers side, where A-pillar meets the sill.

 

^^Again looking for as much of it as possible, with plenty of sill, would buy both sides if people can get them

 

 

And then under the car, i've not cut anything away yet but would be nice to have these bits, the horizontal flat section, i might just cut off the round thing.

[Jim Bowen 1]

bump....Can anyone help with this?

[lilfuzzer 1]

Hi Jim loads of bits there bud. I am struggling to get the rear bumper off this motor but will endeavor to do so

[Jim Bowen 1]

Sills not required now, managed to get them new from VW heritage thanks to a helpful couple of forum members :)

 

I just need the bits on the rear.

[Jim Bowen 1]

ttt