carrots 1 Posted January 15, 2019 ive got some new bolster foam for my seat base.before I start the job I want to see whats best to use to re attach the cloth to the frame.hog rings (I would have to buy rings and tool) or small cable ties.cheers Quote Share this post Link to post Share on other sites
Philly-R6 0 Posted January 15, 2019 I'm not sure you need to buy new rings and a tool. When I replaced my seat foam, I used pliers to undo and refit the hog rings. Just take your time - we are supposed to enjoy these challenges! Quote Share this post Link to post Share on other sites
seanl82 23 Posted January 15, 2019 Yeah I used a set of needle nosed pliers, fed them through the rings then opened them up to remove, then just a normal set of pliers to close them back up again. So long as you don't open them right up, they're perfectly re-usable. Quote Share this post Link to post Share on other sites
carrots 1 Posted January 15, 2019 Cheers I will try that Quote Share this post Link to post Share on other sites
_Matt_ 26 Posted January 16, 2019 I can't directly help but where did you source seat foam? I can feel springs/metal after sitting in my drivers seat for an hour.. Quote Share this post Link to post Share on other sites
carrots 1 Posted January 16, 2019 I am only changing the seat base bolsters I got them off ebay from Germany. Not cheap but they are new Quote Share this post Link to post Share on other sites
