petemcr 10 Posted June 11 (edited) Hi all, I had my 93' VR6 in for an MOT just before I went on holiday, it failed on emissions even though I had a new CAT fitted before that. After looking around I come across a snapped wire on the Lambda harness. I was going to just try to rejoin or put a new pin on, but I'm a little confused. The wire which has snapped looks like it's yellow, which you can see, but the other side looks to be white, but with a black wire in there as they are two wires together. Anyone know off hand which wire should go to the offset pin so I can go repin it. Cheers all Edited June 11 by petemcr Quote Share this post Link to post Share on other sites
fendervg 33 Posted 7 hours ago Can't see a black wire - the lambda sensors come in different versions with different wiring connectors, so it looks like someone may have just bodged one to wire it up to the existing loom - if it was original the colours to the connector would definitely be the same. I'd say just match the broken one to the loose one and you should be ok. Quote Share this post Link to post Share on other sites
