Dancing Fish 0 Posted January 6, 2005 Dudes, How do I detach and re-fit my side repeaters? Is is some kind of putty or glue or something? DF. Quote Share this post Link to post Share on other sites
Phil K 0 Posted January 6, 2005 side repeaters are removed by pulling back and pulling leading edge out. They only clip in and aren't glued as you'd have trouble changing bulbs!!! Quote Share this post Link to post Share on other sites
daves16v 1 Posted January 6, 2005 Watch out, I removed mine and the small tab that holds them in broke....on both repeaters. Luckily I was fitting news ones anyway. Quote Share this post Link to post Share on other sites
Dancing Fish 0 Posted January 6, 2005 Ah, Yo comprendo, One of mine is loose. The tab must have broken. I was a bit unsure as to how the glue would work!!! DOH! Quote Share this post Link to post Share on other sites
VR6 0 Posted January 6, 2005 /Waits for thread: "How do I get back my side repeater leads from inside the wing?" Quote Share this post Link to post Share on other sites
Phil K 0 Posted January 6, 2005 lol... I had that problem when I changed mine!!! Quote Share this post Link to post Share on other sites
Furkz 0 Posted January 6, 2005 take off the plastic arch liner and than try and feed it through :D been there seen that etc etc make sure next time u mask it to the outside jus in case Quote Share this post Link to post Share on other sites
edd 0 Posted January 7, 2005 wire coat hanger bend end into hook stick through hole spend half hour "fishing, hook it pull it, job done. :mad: :) Quote Share this post Link to post Share on other sites
fla 9 Posted January 14, 2005 If you do get no standard repeaters you can just stick tehm on with some cushioned double sided all around the edge. Just make sure the paint is properly cleaned. That s plenty strong enough to hold them but not too harsh that when you need to change the bulbs half the paint comes off. Quote Share this post Link to post Share on other sites
