Part number unknown!!

[andycowuk 0]

Hi

 

My stealer cant locate a part number for a bolt on etka, can anyone help?

 

The bolt I need is one of the 3 which go down into the rear engine mount, but this one also has a threaded shaft coming out the top to hold the braket for the connector block for the lamda probe (and temp sender on later cars)

 

I can get a pic showing the broken one if needed but you should see it easily if you look at yours.

 

thanks

[Kevin Bacon 5]

N90553202 - 82 pence.

 

They bend and break quite easily.

 

Kev

[Henny 0]

yup, I broke mine while taking the engine out... :? bit of a naff design if you ask me... :roll:

[andycowuk 0]

cheers! Howcome you knew it so quick?

[Kevin Bacon 5]

Cause I replaced it in October! I looked on the invoice for ya :lol:

 

Kev

[andycowuk 0]

Kev,

 

the one you rewcomended was a 17mm head, the one I need had a 13mm head.

 

Any ideas?

[Kevin Bacon 5]

Hmmm, not sure in that case. They found it in EKTA no problem when I called them to order mine. AFAIK, the main thread that goes into the engine has a 17mm head and the smaller thread that secures the 02 sensor plug plate is a 13mm head.

 

Are we talking about the same bolt? Mine's the one that drops through the mount from the top, behind the engine block.

 

Kev

[andycowuk 0]

maybe they picked the wrong part at the factory......I need the 13mm one that goes down vertically into the mount.

 

there are 3 x 13mm bolt, one of these holds the o2 sensor.

[Banana Man 0]

Andy the bolt you need by looks of it is N 019 504 2 it's an M8 bolt which is a 13mm headed hex