Vag Com question

[mr.ots 10]

Ran a Vag Com full scan today for the first time on the C and the "Address 01: Engine" was highlighted in red and ended with:

 

"No Faults Found

or DTCs not supported by controller

or a communication error ocurred"

 

Is this the normal response for a C if there are no faults found? Vag Com was definately communicating with the ECU as I could read all of the relevant measuring blocks etc?

 

I only ask this question because when I ran it on my MK3 it ended with:

 

"No fault code found.

Readiness: N/A"

 

So is this the norm?

[mr.ots 10]

Bump.

 

Is there anyone with vag com out there who can veryify this?

[fla 9]

are you using a genuine cable? Also, you did have the ignition on, engine off didnt you? After a scan you should get the 'error' 00513 engine speed sensor. Its not an error, its just recording that the engine is not tunning.

[mr.ots 10]

The cable is an ebay one but seems to work fine. I can read both the Engine and ABS ECU's.

 

I ran a scan with the ignition on/engine off and got the 00513 and with the engine on (no 00513). Measuring blocks show all the relevant data, engine rpm, temps, voltage etc.

 

I just couldn't understand why the scan ended with

 

"No Faults Found

or DTCs not supported by controller

or a communication error ocurred""

 

as if it may have not been communicating, when it didn't do the same on the Golf.

 

I guess it is all working ok, just wondered if anyone else had the "01 Engine" section end with the same message?

[millerman 0]

i have a ross tech key com lead and that says

 

no faults found

 

 

and that is all if there are no faults :D

[Toad 0]

Do you mean you hit Auto Scan?

 

I never bother, just go into engine, and fault codes and it's fine on a non gen cable.

[Reggit 0]

This is a screenshot of mine after an Autoscan. Don't know if it's what you want to compare to?