fendervg 33 Posted September 2, 2015 Hi all - here's a question. The "Basic Settings" ECU reset procedure is quite lengthy as it seem to involve driving the car at normal temperature to "teach" the ECU according to the wiki on here, before you do the reset. Do people do this every time the battery is disconnected? The reason I ask is that very little of the VAG literature mentions doing the procedure in the repair instructions, even for repair groups that involve the battery being disconnected for safety. Most just mention keeping a note of the radio codes! Would I be right in saying that under normal conditions the ECU will just re-adapt anyway after voltage has been interrupted, and that normal driving will be enough for it to calculate the correct values? Quote Share this post Link to post Share on other sites
Jon_vr6 1 Posted September 2, 2015 Some people swear by always doing the reset but ive only done it once in the last 9 years. As you said normal driving should sort it out. If you do have any problems then obviously do the procedure. Quote Share this post Link to post Share on other sites
robrado974 1 Posted September 2, 2015 I've never done this procedure . I've had the battery disconnected plenty of times and never had a problem . Quote Share this post Link to post Share on other sites
fendervg 33 Posted September 2, 2015 yeah - that was what I thought. I've only ever done it a couple of times. The only reason I see where it might be needed is if you don't drive the car after reconnecting the battery and just let it warm up slowly at idle for 20 mins or so - then the ECU would never see full throttle etc. Quote Share this post Link to post Share on other sites
fla 9 Posted September 2, 2015 it also aligns the tps with the ecu. Quote Share this post Link to post Share on other sites
