Advice needed on DIY roof trim refurb

[Bauhaus 3]

Hoping someone who has done this will chime in, I'm looking for some advice on the DIY roof trim refurb, I’ve seen the youtube vid and got both of the rubber seals plus 3m tape,  but what I need to know is how do you cut the outer rubber trim nice and straight over the length of the roof trim to match the end caps?  can’t see cutting it freehand will look good.

Thanks

[fla 9]

tbh i would leave it as is as the edge is cut straight - thats what i'm planning to do on mine especially as i doubt i'll be able to get a proper straight edge by hand and would likely draw my attention more!  I think i can live with it being slightly wider than the end trim.  

[Bauhaus 3]

On 5/30/2022 at 10:51 PM, fla said:

tbh i would leave it as is as the edge is cut straight - thats what i'm planning to do on mine especially as i doubt i'll be able to get a proper straight edge by hand and would likely draw my attention more!  I think i can live with it being slightly wider than the end trim.  

Thanks, I was kind of thinking thats what I would end up doing, as you say its only slightly wider, going to have a bash at refurbing those trims over the next couple of days.

[fla 9]

post up some pics as you progress too

Hasan

[GrahamU 5]

Have you seen this vid

 

https://youtu.be/loz1IB19X8Q

[Bauhaus 3]

On 6/1/2022 at 8:27 PM, GrahamU said:

Have you seen this vid

 

https://youtu.be/loz1IB19X8Q

I did see that thanks, I managed to refurb the trims today, just got to take out the old tape and clean the channels they sit in before fitting them back in before saying how successful it went,. but so far so good.