Linus Van Pelt 0 Posted September 27, 2004 Experience preferred, pictures a bonus, assume I'm an idiot... :cuckoo: Apply within :mrgreen: (If you care, I think I be mostly needing to replace the holder & washer that holds the side of the bumper to the car... #1/#2 on the ETKA diagram...) Cheers ;) LvP. Quote Share this post Link to post Share on other sites
Supercharged 2 Posted September 27, 2004 Think its just 4 bolts underneath... Quote Share this post Link to post Share on other sites
daves16v 1 Posted September 27, 2004 That is correct. They are 17mm. The whole bumper just slides out. Quote Share this post Link to post Share on other sites
Linus Van Pelt 0 Posted September 27, 2004 Thanks for that, I'll take a look... here's the pic, it's not very clear :( Quote Share this post Link to post Share on other sites
STORM 2 0 Posted September 27, 2004 be careful not to cross thread the bolts when you put the bumper back on - easy to do if the bumper is not aligned accurately over the boltholes Quote Share this post Link to post Share on other sites
