exturbo2003

Just checking if you have a g60 fuel pump available please.

cheers RW1

morning guy's long time but still here and now need to have my brain racked the ecu vacuum pipe, now i know 1 meter exactly but i cant remember if its top or bottom take off on the throttle housing help please guys stuart

does anyone know the differance between a 91 and a 92 wing need a 91 but cant find any so need to know if i need 2 later wings cheers

what alarm is it and is it going off same time every night and whats the fan issue

ht howard in slough if not too far. been using andy for 20 years and never has he let me down top dog, not the cheapest but you get a perfect job andy 01753 525549 http://www.hthowardandco.co.uk/ if you do tell him stuart alphatune recommended him

porous float or arm not at correct angle in tank and catching

just a thought but you remove breather and then bts and then rev 3 times over 3000 and allow to idle, set idle speed and then switch off, reconnect bts and breather and restart. but you never mentioned turning off before reconnecting as for hall sensor dont bother yes you can change it but its a pain as bits are a interferance fit and hence very tight so would recommend a new dizzy every time

l

The problem with the motor codes scheme is that it costs the garage and if you belong to another scheme you cant join. PAS pumps are easy to get so he defiantly didnt need to fit a renault pump, and if the pressure and flow rates are wrong it will take out your rack as well Pricing parts is different as euro car parts sell stuff on their website at trade prices so the garage is always going to go with the rrp quoted so as to make a bit of money on the parts as they did the ordering and the warranty is against them if the bits fail. They can claim the parts back but not always the labour and if they try invariably they lose and get no new part or labour. Also did they get the bits from ecp as not all garages can get deliveries from all suppliers so they might be supplied by a more expensive supplier. That said this is a disgusting display of why garages get a bad name

how can you tell differance between dealer and factory fit on early rado's mines a late 91 as far as i know factory but the switch has 5 pins on each switch and piggy back wires between the switches if thats factory how do i wire them to new switches

reprogramming a new remote is easy, it should be in your manual but if you need to reprogram it you input your code then hold the sprung side of your switch till the alarm beeps 1 time after about 3 seconds, now you are in program mode so if your code is 2then you do the following 1: press sprung side twice and then latch once 2: immediatly press and hold sprung side for about 3 seconds until you hear a beep 3:now press latch side twice and wait for 2 beeps 4:press rocker side once(alarm will beep as you press switch) 5:now press alarm lock button and alarm should beep 2 chirps for confirmation if 1 chirp press lock button again 6;switch off ignition alarm will beep 5 times to confirm exiting from program mode test remote if this doesnt work if could be the remote but would need it to test it try it if not pm me for my number and will try and talk you through it stu

glad to help

think you should find it has a lifetime warranty

also is it near a wall to the kitchen and have a new microwave fitted