Jump to content
Wayne2015

White VR6 in Windy Yorkshire! :)

Recommended Posts

Van

 

 

Don't know - not sure what type of van it is - could be a racing van stripped out :shrug:

Share this post


Link to post
Share on other sites

Got someone from the states asking questions about my C now :eek:

 

Should I worry? :shrug:

Share this post


Link to post
Share on other sites
What's the latest Wayne? Have you sold?

 

 

Nah, Andy

 

Lots of enquiries

Lots of PX offers

A few low offers ...but holding out until I desperate to sell or found replacement (whichever earliest) ...

Share this post


Link to post
Share on other sites

If you don't mind some constructive comments having looked at your ebay advert;

 

1. Make a bigger fuss of the money you've spent on her as you've spent thousands! List that early on and summarise what you've spent on.

2. Take a few minutes to wipe over the slam panel, suspension turrets and washer bottle under the bonnet (at least these items) and stick a new engine photo up. It will look much fresher.

3. Assuming the paint is ok underneath, lose the sticker on the fuel filler flap with a hair dryer or gently with a heat gun

 

I think the above will make your car much more appealing. You've been honest about it's condition (as you should be) but sell the plus points a little more as it's not all bad! :thumbleft:

Share this post


Link to post
Share on other sites

None of the PX offers suitable replacements of r do you have your mind set on something particular? - either way good luck mate

Share this post


Link to post
Share on other sites
If you don't mind some constructive comments having looked at your ebay advert;

 

1. Make a bigger fuss of the money you've spent on her as you've spent thousands! List that early on and summarise what you've spent on.

2. Take a few minutes to wipe over the slam panel, suspension turrets and washer bottle under the bonnet (at least these items) and stick a new engine photo up. It will look much fresher.

3. Assuming the paint is ok underneath, lose the sticker on the fuel filler flap with a hair dryer or gently with a heat gun

 

I think the above will make your car much more appealing. You've been honest about it's condition (as you should be) but sell the plus points a little more as it's not all bad! :thumbleft:

 

 

Cheers Andy

 

Will do as much as I can :thumbleft:

Share this post


Link to post
Share on other sites
None of the PX offers suitable replacements of r do you have your mind set on something particular? - either way good luck mate

 

Nah David

 

Not want modded Audi s etc

Share this post


Link to post
Share on other sites

Well

Didnt want to remove fuel flap DUB sticker until I was ready to polish and re-spray in last house.

 

Now that I have moved house, no chance :(

 

 

Still,

As Andy (Hairyarse) said, better to remove

 

Lets see whats underneath the sticker :eek: ...

 

65881B70-9578-40DF-B9AA-624C2CDAFC59-1405-000002C777C2B6FE_zpsgdlaiqg0.jpg

 

10DA4C0F-5BB8-4E49-8DA1-289F49ADA02F-1405-000002C77D913D95_zpsfyj8v4o3.jpg

 

FC3E3545-2A5E-426F-A452-F796A35A0CCC-1405-000002C782759FCD_zpsopy0z7pr.jpg

Share this post


Link to post
Share on other sites

Just checked weather forecast...

Its going to pee down tomorrow :eek:

 

 

Ok

I got a rusty fuel flap by Monday then :(

Share this post


Link to post
Share on other sites
Ah poop!! Buy a piece of white vinyl?

 

 

Hmmmm

I always like to do it proper or not at all

(That is a respray of flap if I could).

 

In this case might have to buy a white vinyl ...

I hate doing things by 1/2 or cheap fixes :( :( :(

Share this post


Link to post
Share on other sites

Did think about removing the flap

 

And rub/sand at home inside a cardboard box then respray ..

 

With no outside space - its still not good with all that paint smell inside house :eek: :shocked!:

Share this post


Link to post
Share on other sites

Right

 

Did a little think,

Think I can live with the following ...

 

 

1. Use Tardis or glue-removal to remove any sticky glue residue

- if not try a wet/dry sanding off

2. Polish, clay then sealant (will protect bare metal spot bits)

3. Carbon wrap the flap in white (waterproofs it so no rust and will look good too :o)

 

8B24A211-1683-4F84-9D3A-688BD6511A7E-1759-000003305832A325_zpsj6u1oszg.jpg

 

 

Good? :thumbleft:

Share this post


Link to post
Share on other sites

Just flat it down with 400 ,primer it and paint it.that rap stuff will be a completely different colour

Share this post


Link to post
Share on other sites
Just flat it down with 400 ,primer it and paint it.that rap stuff will be a completely different colour

 

 

Was what I planned before I moved.

But I have no outside space at all now (live in a flat).

Share this post


Link to post
Share on other sites

Can you do it outside but as you say I'm a box? One warm evening this week when the heat of the sun has gone

Share this post


Link to post
Share on other sites

something like that can easily be done outside with spray can , where a glove and hold it from the hinge as you spray it, then bring it straight inside being careful not to hit it, place it by an open window, you want the air/draft forcing out of the room/window so make sure you open the right one's depending on wind conditions, failing that im sure it would be fine in bath room with extractor fan on .

Share this post


Link to post
Share on other sites
I feel bad for making you remove the old vinyl now Wayne! :( I'd paint it for you if was anywhere close

 

Not your fault, Andy!

 

There is nothing bad underneath the sticker, just some paint come off - so nothing major!

 

Relax :)

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...