G60 Electrical Q's

[Stone0311 0]

Hi All,

Now finishing up wiring ect for my transplant but have a few loose ends, any help appreciated:

 

Blue and Black temp sensors:

I have 4 wires (plugs missing atm) which don't seem to match bentley:

Brown, white/brown, brown/green, yellow/green

 

Reverse switch:

Can anyone confirm black/red and black/blue to plug?

 

Oil pressure switches:

Have Yellow which is high oil pressure?

Also have blue/white and green/black, one of these is low oil pressure which don't seem to match my bentley?

Not sure what the other is?

 

I may have missed something obvious in the items above, loom is new to the car and engine

 

Thanks

 

Sent using Tapatalk

 

 

[Keyo 47]

The one shown loose does not connect to anything it left the factory tidy like that just leave wrapped up in loom .  Seen this on a few g60 all the same- I will get the other bits for you . 

Edited May 3, 2022 by Keyo

[Keyo 47]

[Stone0311 0]

@Keyo - Thanks m8, much appreciated

Couple of others if you know:

 

> Have a stray brown/white loomed up with the o2 pot sensor?

> Have a blue cable with single plug which I understand to be the 'alternator excitor wire' - where does this connect? (image attached)

 

Thanks in advance

 

Sent using Tapatalk

 

 

 

 

[Keyo 47]

54 minutes ago, Stone0311 said:

@Keyo - Thanks m8, much appreciated

Couple of others if you know:

 

> Have a stray brown/white loomed up with the o2 pot sensor?

> Have a blue cable with single plug which I understand to be the 'alternator excitor wire' - where does this connect? (image attached)

 

Thanks in advance

 

Sent using Tapatalk

 

 

 

 

 

[Stone0311 0]

Thanks

Sent using Tapatalk

[Stone0311 0]

Morning all,

looking to run the engine loom as close to stock as possible, has anyone got any pics of the general cable route from the headwall nr the coil across the engine?

In particular route from alt to starter, head to temp sensors/oil sensors and ISV

Thanks 

[Stone0311 0]

Got a green cable coming from the engine bay to the fuse box, test shows it coming from the digifant connector on the highlighted pin
Anyone have any ideas? Can't seem to find it on any wiring diagrams

[Bauhaus 3]

if that is pin 16 on the G60 ecu connector then that wire is not used, unless you have aircon.

[Stone0311 0]

Thanks @Bauhaus

👍

[Stone0311 0]

Anyone know the part number for these clips on a G60?
Also interested if anyone has any 👍