Door handle repair kit..........THEY ARE NOW AVAILABLE

[GrahamV 10]

1 pair for me just in case please

 

1993

Edited September 19, 2018 by GrahamV
Text

[daves16v 1]

1 pair for me just in case please

 

1993

 

PM sent

[ferarrifeet 0]

Hi, looking for a set for 1996 vr6. thanks

[daves16v 1]

Hi, looking for a set for 1996 vr6. thanks

 

PM sent

[ferarrifeet 0]

payment sent. thanks

[HarveyVR6 10]

Hi Dave, are these still available ?

[daves16v 1]

Hi Dave, are these still available ?

 

Yes they are, drop me a PM for payment details.

 

Thanks

Dave

[bobsinclare 0]

Hello i need a pair please thanks

[daves16v 1]

Hello i need a pair please thanks

 

PM sent.

[Neilalexb 10]

Can anyone tell me how to fit the white c clip to a corrado door handle please?

[crazygamerm2 10]

Pmd you Dave. I hope these are available as I cannot source replacements for my 93 VR6. Just got her all up and running again with a full engine swap, now the door handles are preventing me from driving it haha.

[Erallus 10]

Hi Dave, are these still available as well please?

[daves16v 1]

Hi Dave, are these still available as well please?

 

Yes still available.

[peachers 10]

Hi, just wondered if these were still available? Need one for my VR6

[daves16v 1]

Hi, just wondered if these were still available? Need one for my VR6

 

Yes still available, will PM you.

[dap1275 11]

Hi Dave, can I order a pair for my `92 G60 please?

[daves16v 1]

33 minutes ago, dap1275 said:

Hi Dave, can I order a pair for my `92 G60 please?

Yeah sure, I'll drop you a PM.

Dave

[dap1275 11]

Pair arrived as promised and I fitted the passenger side yesterday, was a bugger to get the pin out but the instructions supplied were spot on. Thanks, Dave!

[fendervg 29]

I found the easiest way was to use a small punch or screwdriver to hammer it out towards the back of the handle, to break off the metal covering, and then once that goes, push it back out towards the front.

The real tricky bit for me was to re-assemble the spring onto the lock tabs - if you can avoid taking this bit off, it's much easier.

[daves16v 1]

5 hours ago, fendervg said:

I found the easiest way was to use a small punch or screwdriver to hammer it out towards the back of the handle, to break off the metal covering, and then once that goes, push it back out towards the front.

Yes this is in the install guide.

[fendervg 29]

Yes this is in the install guide.

Ha ha Daves16v - that’s exactly where I got it! Worked a treat. I did try to drill one out before, but it’s quite tricky and easy to damage the rest of the mechanism. A reverse tap might work with the spring tension off once it is in.

[Pete S 0]

Hi Dave,

if these are still available can I please order a pair for my 1990 1.8 16v 👍

Regards Pete 

[daves16v 1]

1 hour ago, Pete S said:

Hi Dave,

if these are still available can I please order a pair for my 1990 1.8 16v 👍

Regards Pete 

PM sent.