VR6Steve 0 Posted March 31, 2006 Hello guys, I have a problem with the headlamps on my 94 spec VR6 misting up. Am I correct in thinking that the front glass can be removed? Does the whole headlamp unit need to be removed to do this? Will fitting new seals cure the problem? Cheers, VR6Steve. :roll: Quote Share this post Link to post Share on other sites
Trig 0 Posted March 31, 2006 Yeh you'll need to remove the whole headlight. Flip the bonnet and it's all pretty self explanitory. 2x bolts per light to remove the units, unplug them obviously. Then the plastic trim unclips, finally remove the metal clippy things and the glass lens comes off, be careful you don't drop it. I'd do it all on a towel or something! As far as seals go i'm not sure, the metal clips insure that the seal is tight, you might need to adjust these to create a proper tight fit. HTH. Quote Share this post Link to post Share on other sites
dinkus 10 Posted March 31, 2006 The Headlight Lens Replacement article at your service ;) Quote Share this post Link to post Share on other sites
STORM 2 0 Posted March 31, 2006 Yeh you'll need to remove the whole headlight. Flip the bonnet and it's all pretty self explanitory. 2x bolts per light to remove the units three screws per light even :) Quote Share this post Link to post Share on other sites
Phil K 0 Posted March 31, 2006 Do they have replacable seals then? And should they be replaced if you open the units up for any reason? Quote Share this post Link to post Share on other sites
Trig 0 Posted March 31, 2006 I don't think they are very easily replaced, it's all sort of integrated into the light housing. You could probably buy some kind of squishy rubber stuff to run around the bit where the lens butts up. STORM 2, 2 screws I believe..? :) Quote Share this post Link to post Share on other sites
dinkus 10 Posted March 31, 2006 STORM 2, 2 screws I believe..? :) You're a screw! :lol: 2 at the top and the hidden one down below, as per the photos in the how-to guide... You can also buy new seals 535 941 119 "gasket" according to ETKA. No idea how much they are tho. Quote Share this post Link to post Share on other sites
Trig 0 Posted March 31, 2006 Oh yeah... I didn't even know about that one, never used it! Quote Share this post Link to post Share on other sites
VR6Steve 0 Posted March 31, 2006 Great stuff! Thanks everyone. VR6Steve. :D Quote Share this post Link to post Share on other sites
