JT 0 Posted November 7, 2003 thats a quick 16v 198 in torque thats more than my vr6!!!!!!! :!: Quote Share this post Link to post Share on other sites
Kevin Bacon 5 Posted November 7, 2003 Many reasons why it's impossible to get a representative performance figure without specialist equipment... Bang on the nail..... When I had my Golf 16V Turbo (220bhp), I could have sworn it was pulling low 6s to 60, but imagine my surprise when it was GPS timed at 7.13 seconds and 139.9 Vmax! The car did spin though..... On the day (The Golf Bruntingthorpe thrash), higher spec'd cars were getting even slower times than mine, largely due to spin and poor launches, bad gear ratios etc. Jabbas red rallye pulled a 4.4 second though :? Don't get me wrong, 7.1 seconds is still quick but it just shows that what you perceive as being quick is often not the case when accurately timed. Quote Share this post Link to post Share on other sites
PhatVR6 0 Posted November 7, 2003 Spinning the wheels will not give you a good 0-60 time. It's a meaningless figure nayway, since when do you stop at 60?? Go to a drag strip and lets see your 60' time, I've managed a 2.034sec, which is the best result I've ever seen for ANY FWD car at York Dragway. Quote Share this post Link to post Share on other sites
Bally 0 Posted November 7, 2003 :shock: something can't be right, you sure your cars standard Chris? Quote Share this post Link to post Share on other sites
me32dh 0 Posted November 7, 2003 The team at GTI International 2003 recorded me managing 0-60 in 5.99 secs. I needed a new clutch the following day. I questioned the accuracy on the day, but they said that the laser gun doesn't lie. Standard VR6 with about 100ml of fuel on board. Quote Share this post Link to post Share on other sites
GRINGOG60 0 Posted November 7, 2003 I reckon mine must be sub 4 seconds in that case!!!! :lol: Didnt relise my car was quicker than a Mclaren F1 :lol: Quote Share this post Link to post Share on other sites
chris CORRADO 0 Posted November 7, 2003 i can't help it when i put my foot down the wheels spin (even without reving even creaping along with the cluch fully released and then flooring it just goes then when i slam it into 2nd starts spinning still..... and yer as far as i know the car is compleatly standard it has also done 103,000 miles..... :twisted: :mrgreen: ohh well what does a VR6 run at?????? also the car is a K reg 1993 so what is the speedo will that be electronic or cable????..... Quote Share this post Link to post Share on other sites
dr_mat 0 Posted November 7, 2003 That torque curve is certainly NOT from a "standard" 2.0 16V!! First off, it's torque is peaking at only 3.5k rpm and tailing off - standard 2.0 16V is definitely the other way about. Second - redline is too low for a "normal" 16V, iirc they go to 7.5k rpm. Looks more like a turbo 8v engine, or even a G60. Suppose it could be a 2.0 8V with G60 conversion, but there's no way that's a "standard" 2.0 16V... Tip: listen for a little whistling noise when it starts "really going for it"... Quote Share this post Link to post Share on other sites
VR6 0 Posted November 7, 2003 Chris - either please don't create duplicate accounts or please ask your friends/family not to register just for a laugh. If they geniunely want an account, fair enough. Quote Share this post Link to post Share on other sites
dr_mat 0 Posted November 7, 2003 The team at GTI International 2003 recorded me managing 0-60 in 5.99 secs. I needed a new clutch the following day. I questioned the accuracy on the day, but they said that the laser gun doesn't lie. Standard VR6 with about 100ml of fuel on board. I can just about believe this. If it's on a highly grippy sprint track with very little weight in the car, yeah I can believe that. I've seen official figures for the VR6 of between 6.2 and 6.9 seconds 0-60, and they will have been aiming for "normal conditions", so no ultra-grippy racetracks for them! Quote Share this post Link to post Share on other sites
chris CORRADO 0 Posted November 7, 2003 any way guys i don't know why my car like this but all i know i wanna show you guys at ace cafe one day if i can get a tuesday off work!!! :mad: i wanna show up alex... LOL not really m8 love your car m8... Tip: listen for a little whistling noise when it starts "really going for it"... there is a kinda whisle noise when you change between gears (and not it is not a dump valve) i will try and get that video soon and also an audio clip...... cya Quote Share this post Link to post Share on other sites
dr_mat 0 Posted February 3, 2005 (Just resurrecting this little old thread to add background to the recent video posted in another thread.) Quote Share this post Link to post Share on other sites
K-rado 0 Posted February 3, 2005 And your diagnosis Dr Matt? Oh sorry, you don’t need to be a dr to work that one out. I have read it all (again) but to polite to comment anymore and dont wanta upset Chris :D My Vr6 is running sweet, Has been serviced by a TVR specialist for the past 6 services or so and I would guess tweeked a little by the former owner. I would put money that my Vr would do a sprint (on a good day) circa 6.2 With Chris’s rado with his few tweeks, I would guess on a Very Good day 7.4. Cant wait for the conclusion to this. :-P Quote Share this post Link to post Share on other sites
Guest Posted February 4, 2005 Can't remember if i've mentioned this on here, or on Yahoo groups, but just to add to this thread. I've been timed twice in my VR, which is standard. First time was a GTi International a few years back, weather was scorching, and i got 6.81s. Second time was at Trax, but it started to rain on my go, so the track was damp. Still managed 7.07s though. Chris, is there anyway that you could post a photo of your engine? That could easily reveal to us if it had a turbo, or other mods of some sort. There's no way a standard 16v will reach 60 in less than 7 seconds... Cheers Steve Quote Share this post Link to post Share on other sites
Scott 0 Posted February 4, 2005 Mmmmmmmm I've timed my car with a G Tech pro and got 0-60mph in 6.08 secs.... thats running 12psi@220bhp... How on earth can you get 6.5 secs with just 138bhp? Quote Share this post Link to post Share on other sites
dr_mat 0 Posted February 4, 2005 Funny, we've been asking for a photo of the engine since this thread appeared way back when... And Scott: you CAN'T get 0-60 in 6.2 with 138bhp, unless it's a diesel!! Quote Share this post Link to post Share on other sites
Henny 0 Posted February 4, 2005 tafkadm, depends on what the 138BHP is in... Stick it in a Motorbike and you'll happily get a 3 second 0-60! :lol: Quote Share this post Link to post Share on other sites
dr_mat 0 Posted February 4, 2005 I was about to edit my post and add "unless you're driving a motorbike!! :) Quote Share this post Link to post Share on other sites
chris CORRADO 0 Posted February 4, 2005 as requested Quote Share this post Link to post Share on other sites
chrishill 0 Posted February 4, 2005 it should be noted that red paint adds at least 100bhp. Quote Share this post Link to post Share on other sites
chris CORRADO 0 Posted February 4, 2005 LOL nevermind.... Quote Share this post Link to post Share on other sites
coolrado 0 Posted February 4, 2005 i think i have the answer!!! do you have either of these in the car ?? :lol: Quote Share this post Link to post Share on other sites
slot 0 Posted February 4, 2005 Bet he dont need road's neather !! :D Quote Share this post Link to post Share on other sites
Scott 0 Posted February 4, 2005 Funny, we've been asking for a photo of the engine since this thread appeared way back when... And Scott: you CAN'T get 0-60 in 6.2 with 138bhp, unless it's a diesel!! A diesel wont even do that either ;) Quote Share this post Link to post Share on other sites