Matt GTi 0 Posted June 24, 2004 I was giving my car some beans last night, and as i approached the redline in first and second, my handbrake light flashed on and off. Any ideas why? Perhaps it's a shift light that VW didn't tell us about! :lol: Quote Share this post Link to post Share on other sites
dr_mat 0 Posted June 24, 2004 It was your passenger trying to slow you down.. Didn't you notice?? ;) Quote Share this post Link to post Share on other sites
Matt GTi 0 Posted June 24, 2004 To be honest that wouldn't have surprised me! :lol: Quote Share this post Link to post Share on other sites
corradovr6sc 0 Posted June 24, 2004 Could be a low brake fluid level or dodgy sensor on the reservoir cap. Quote Share this post Link to post Share on other sites
dazzyvr6 0 Posted June 24, 2004 or a low pad wear indicator Quote Share this post Link to post Share on other sites
daves16v 1 Posted June 24, 2004 or a dodgy handbrake switch. Quote Share this post Link to post Share on other sites
Henny 0 Posted June 24, 2004 I'd go with low brake fluid... check it and top it up if needed (don't fill it to the top though, as when you next change the pads you'll overflow it as you push the pistons back in! ;) Quote Share this post Link to post Share on other sites
ben16v 0 Posted June 24, 2004 also if it keeps happening check your clutch slave, thats what mine did first but not on some others on here?! Quote Share this post Link to post Share on other sites
Linus Van Pelt 0 Posted June 24, 2004 According to Mr Manual... The Warning Lamp comes on when: (1) The Handbrake is on (duh!) (2) The Brake Fluid level is too low (3) With ABS it also indicates that the pressure in the pressure accumalator is too low ...Unless you're in my car where the led is bust :lol: I have the replacement, just not got round to fitting it :oops: DtM. Quote Share this post Link to post Share on other sites
vr6storm 0 Posted June 24, 2004 fi the fluid level is fine..........i'd go with it being a dodgy sender in the cap.......mine did this when i first bougth it......and just gave the plunger a few movements up n down and its not given any problems since Quote Share this post Link to post Share on other sites