Erallus 10 Posted August 2, 2017 Found this : Quote Share this post Link to post Share on other sites
Jim 1 Posted August 2, 2017 Nice - good find! Will have to have a watch of that later :) Quote Share this post Link to post Share on other sites
culshaw 1 Posted August 2, 2017 Related: how to build a vr6 block Quote Share this post Link to post Share on other sites
Swompy 0 Posted August 3, 2017 I do enjoy watching this guys videos easy to follow and full of information Quote Share this post Link to post Share on other sites
Geeba 0 Posted August 3, 2017 Really good video! - top find Quote Share this post Link to post Share on other sites
ger040 2 Posted August 3, 2017 i wondered where Arron out of gas monkey garage ended up! Quote Share this post Link to post Share on other sites
Jim Bowen 1 Posted August 3, 2017 Nice video that, i think i'll build my next bottom end myself Quote Share this post Link to post Share on other sites
Erallus 10 Posted August 3, 2017 I do enjoy watching this guys videos easy to follow and full of information He has a full series of video's on his VR6 golf project, very good to watch. Quote Share this post Link to post Share on other sites
fla 9 Posted August 3, 2017 Good clip and what an unbelievably clean engine right down to the screws etc! Quote Share this post Link to post Share on other sites
Kevin Bacon 5 Posted August 4, 2017 Yeah saw it the other night....and cringed when he said it doesn't matter where the intermediate pulley lines up.....but he had the arrow facing north in the end, which was good. Quote Share this post Link to post Share on other sites
Jim Bowen 1 Posted August 4, 2017 I was thinking if the pulley etc is off then as long as the flat bit is on top that's ok? Quote Share this post Link to post Share on other sites
Kevin Bacon 5 Posted August 4, 2017 What he did was 100% spot on. It was just his words didn't always add up :) Quote Share this post Link to post Share on other sites
