Jim 1 Posted February 27, 2004 I feel really lame asking but.. how are you supposed to get them off so I can replace them with new ones?! :) I tried turning em, and they seemed to spin round to a new position.. but they didn't come undone. Tried pulling on them, they didnt budge. Ta :) Cheers. Quote Share this post Link to post Share on other sites
Tempest 0 Posted February 27, 2004 Are they locked bolts (i.e. anti-theft bolts) for which you need a special key? Tempest Quote Share this post Link to post Share on other sites
Henny 0 Posted February 27, 2004 they just pull off, but they're tight to stop 'em falling off... ;) you may want to put something like a metal ruler in the gap (a nice and wide flat thing anyway) to lever them out... 8) Quote Share this post Link to post Share on other sites
dubster82 0 Posted February 27, 2004 hehe i just ran outside to check mine. (feel pleased, its snowing here lol) remove the centre cap with a scew driver leavering it off. it should become obvious after that.... but if it doesnt... buy a saxo :lol: only kiddin jim :wink: its just a series of plastic clip for the badge aND more for the whole bolt. so you can just swap the badge if you want... Quote Share this post Link to post Share on other sites
Jim 1 Posted February 27, 2004 Cool.. might swap em over before I go home then as I have a full set of nuts & BBS badges now thanks to OSV :D Quote Share this post Link to post Share on other sites
dubster82 0 Posted February 27, 2004 it should take ya less that 10 minutes to be honest. BUT!!!!!!! the wheels are old and the plastic my be brittle.. so careful :wink: Quote Share this post Link to post Share on other sites
Jim 1 Posted February 27, 2004 The plasic is very brittle but nothing snapped, and I am now BBS capped. Took about 10 minutes ;) Ta :) Quote Share this post Link to post Share on other sites
dubster82 0 Posted February 27, 2004 no probs jim :wink: Quote Share this post Link to post Share on other sites
