Stonejag 10 Posted March 8, 2014 (edited) My entire house is full of Corrado parts and it's winding me up :lol: Will my loss be your gain? Pics available on request. All prices posted. Free stuff to be collected or postage paid. Front upper strut brace - genuine OMP part. Black powder-coated bar, natural aluminium strut top plates. Slightly diffferent shape to the polished one but again won't fit a VR6 - from memory I think it fouls on the brake fluid reservoir, but could probably be made to fit with some fettling / relocating. £80 collected or £100 posted. 24v oil pump - improves oil pickup if you're using a 24v sump on your VR (sits slightly lower than the 12v sump). Note this won't fit in a standard steel sump. Good working order. £30 Small and large headlight rear caps - 2 of each size available - free. Headlight reflector assembly - right side. Excellent condition - ideal for Joey modding. £20. Left headlight outer bezel - free Left headlight glass - no cracks - and rubber seal. £10 Internal headlight wiring harnesses - 2 available, £3 per side. Complete right headlight assembly (believed to be late, marked 132 806-00) - near-perfect glass, fully working but top two retaining tabs snapped £30 Plastic windscreen wiper trim surround x2 (not sure which sides - part numbers 536 853 845 and 536 853 830) - free VR6 exhaust heat shield (solid type) - bit of pitting but would clean up nicely with a wire wheel. I started on this but then got bored and got one chromed instead! £10 Thanks for looking :) Stone Edited April 24, 2016 by Stonejag Quote Share this post Link to post Share on other sites
ross k 10 Posted March 8, 2014 messaged about headlight adjuster Quote Share this post Link to post Share on other sites
Roger Chatfield 0 Posted March 8, 2014 When you say internal headlight wiring do you mean the actual wiring inside the light unit?? If so can I have both sides please. Rog. Quote Share this post Link to post Share on other sites
diarmaid16 1 Posted March 8, 2014 Have you got a pic of the front upper strut brace? Quote Share this post Link to post Share on other sites
mrginge 0 Posted March 8, 2014 (edited) Price posted for dipstick, rear upper brace, bmc hose and engine cover please. Edited March 8, 2014 by mrginge Quote Share this post Link to post Share on other sites
Stonejag 10 Posted March 8, 2014 When you say internal headlight wiring do you mean the actual wiring inside the light unit?? If so can I have both sides please. Yes, that's what I meant. Bearing in mind that the outside part of the 4-pin external connector is part of the plastic outer housing, do you also need this bit cut out or just the white plastic insert that fits into the middle? PM me with your address and I'll let you know payment details. Have you got a pic of the front upper strut brace? Price posted for dipstick, rear upper brace, bmc hose and engine cover please. £50 total posted. Quote Share this post Link to post Share on other sites
mrginge 0 Posted March 8, 2014 Well if everything is in good nick Im up for £50. Pm me PayPal, cheers. Quote Share this post Link to post Share on other sites
easypops 8 Posted March 8, 2014 I'll cover the postage plus a bit on the wishbones if that's ok? :) Quote Share this post Link to post Share on other sites
stuarttaylor37 13 Posted March 8, 2014 Hi could I have a photo of VR6 exhaust heat shield (solid type) - bit of pitting but would clean up nicely with a wire wheel. I started on this but then got bored and got one chromed instead! £10 to see if its the right one I'm after and claim dibs until I've seen it please? Thanks Stu Quote Share this post Link to post Share on other sites
seanl82 23 Posted March 8, 2014 I'll take the strut caps posted please! - assuming they're for a VR? Cheers! Quote Share this post Link to post Share on other sites
Roger Chatfield 0 Posted March 8, 2014 Mate, just realised I don't actually need these. Sorry to mess you about. Rog. Quote Share this post Link to post Share on other sites
diarmaid16 1 Posted March 8, 2014 I'll leave the strut brace thanks Quote Share this post Link to post Share on other sites
gNo 10 Posted March 8, 2014 Hi, Interested in both wings if my brother can collect them for me. He's at Potter's Bar which doesn't look far from you. I will try and contact him and let you know. Quote Share this post Link to post Share on other sites
Stonejag 10 Posted March 8, 2014 I'll cover the postage plus a bit on the wishbones if that's ok? :) Mate, to be honest they're really too heavy to post at anything approaching a reasonable rate. Happy for you to send a courier if you like though, I've always been happy with Paisley Freight who are your side of the border... I'll take the strut caps posted please! - assuming they're for a VR? Cheers! Yes they are - grabbed them for my Golf thinking they were the same size but it has smaller strut tops. Stuck them in the ultrasonic bath for you and they've come up quite nicely. Hi could I have a photo of VR6 exhaust heat shield (solid type) - bit of pitting but would clean up nicely with a wire wheel. I started on this but then got bored and got one chromed instead! £10 to see if its the right one I'm after and claim dibs until I've seen it please? Thanks Stu Should have specified this is the type that fits on top of the exhaust manifold, not the under-car one. No point in chroming those :lol: I'll leave the strut brace thanks Did you see the OMP one peeking out behind it? Was saving it for the Golf but I'll part with it for £80... Stone Quote Share this post Link to post Share on other sites
easypops 8 Posted March 8, 2014 Mate, to be honest they're really too heavy to post at anything approaching a reasonable rate. Happy for you to send a courier if you like though, I've always been happy with Paisley Freight who are your side of the border... Happy to do so mate, I'd need a rough size and weight......only if you can be bothered :) Quote Share this post Link to post Share on other sites
seanl82 23 Posted March 8, 2014 Excellent, can you let me know how much with postage and your details and I'll get funds across buddy. Cheers Stone! Quote Share this post Link to post Share on other sites
stuarttaylor37 13 Posted March 8, 2014 I'll pass on the heatshield thanks I was hoping it was the top one on the bulkhead Cheers Stu Quote Share this post Link to post Share on other sites
Stonejag 10 Posted March 8, 2014 Hi, Interested in both wings if my brother can collect them for me. He's at Potter's Bar which doesn't look far from you. I will try and contact him and let you know. That'd be fine, just let me know and we can sort times out etc. Happy to do so mate, I'd need a rough size and weight......only if you can be bothered :) They're approx 30cm x 50cm so probably end up approx 75x75x50 when packaged. No idea as to weight - would have thought 15kg should cover it? Stone Quote Share this post Link to post Share on other sites
diarmaid16 1 Posted March 8, 2014 Did you see the OMP one peeking out behind it? Was saving it for the Golf but I'll part with it for £80... Stone Ya, would have liked something like the omp one but good luck with the sale anyway Quote Share this post Link to post Share on other sites
dickie 0 Posted March 9, 2014 I'll take the steering wheel boss , send over a posted toal and PayPal please. Quote Share this post Link to post Share on other sites
Ruggy 10 Posted March 9, 2014 Hi mate, interested in the passenger side head light. Have you got pics, need to see if it's better than the one already on the car. Cheers Headlight reflector assemblies - left and right available. Good condition - ideal for Joey modding. £15 each. Quote Share this post Link to post Share on other sites
Ruggy 10 Posted March 9, 2014 Hi mate, interested in the passenger side head light. Have you got pics, need to see if it's better than the one already on the car. Cheers Quote Share this post Link to post Share on other sites
MrtinRP 10 Posted March 10, 2014 (edited) I'm looking to go low in the near future.. can you pm me pics of the plated sump please. Can you post it? Cheers Edited March 10, 2014 by MrtinRP Quote Share this post Link to post Share on other sites
Stonejag 10 Posted March 11, 2014 Sure, will get some pics up later on. Yes, I can post it. Ruggy: are you after the complete headlight or just the reflector? Quote Share this post Link to post Share on other sites
Ruggy 10 Posted March 11, 2014 Just the passenger side reflector assembly. Quote Share this post Link to post Share on other sites
