W3RKD
-
Content Count
3,897 -
Joined
Everything posted by W3RKD
-
i guess it all comes down to the offset again though ehh :D
-
ok i suppose it depends on how low you are running the car ... all i can say is that i have fitted and run for over a yr 9-16"s and they have never come anywahere near to touching my koni coilovers ...
-
fitting coilovers makes fitting a whole load easier ... look at one compared to a std rear shock /spring assy and look how thick a std set up it it would rub alot more...
-
humm still no pics of the ladies on there corrados yet then ?? :lol:
-
yes im trying to get up there too..
-
as i said earlier and as valver says ! et20mm is a much as you can go with a 9"rim i have had very slight arch work and mine are fine... you dont really have much hope with et35mm 9" rims you as i would say your main rubbing will be coming from the inside.... p.s the rear of my car is lower than that as it was parked on the lumpy ground ..
-
i dont think the grey one is to bad...
-
i have just re-red the post again and i have made a mistake ? mine are 16"'s not 17"s sorry ...
-
et15 mm where are they rubbing ...
-
like these ? :lol: ... 9" go on but you need to be careful when choosing offsets ...
-
where were all the g60's then as there are no pics of any ??? :(
-
how did mr hartly do then ??
-
so who was quickest then ... :lol:
-
this was done as a special request for a friend who has just carried out a g60 conv into a mk1 cabby... i dont plan on really selling these as im concentrating on the front mount intercoolers at the moment... but if someone asked nicley i could have my arm twisted to do another one ! :lol: the whole kit can be supplyed ie pump/rad/swirl pot / pipe-work but no plans to really produce large numbers at this time ..
-
think this should cure the heatsoak of a std corrado g60 intercooler.. :lol:
-
had it for ages ... try google there's more pics on there of it..
-
here you go ...
-
alsoif you going to have the charger serviced you might aswell have it ported then you are killing too birds with one stone.... "peace of mind and upgrading all in one""
-
custom inlet aint hard to get hold off atall mate as im gonna be providing then as parts of the x-flow kit...
-
imho go and buy that car now .....
-
rack ... you could build an awesome g60 engine for that money there are quite a few choices really... also designa-dubs would charge £1k to fit a 20vt in your raddo / but you dont wanna do that do you really! :lol:
-
good luck with the car..! leew done a great what to look for guide on this forum... doa serch for it if i were u as it has loads of pricless info on it..... i think i regonise that g60 ?
-
my prefer'd oil is synta siver too... costs around £10 a pop to so bonus...
-
i have some spare outers too.... as i have the fk's now...
-
i try'd that and it wasn't much better.... :lol: