CoxyLaad

hes probablies knocking one out lol :lol:

ah, hence the total lack of damage to the rear bumper

sounds like copper corrosion. just clean it up with a nail file and smear a bit vasaline on it to stop it happening again

Cheers Lotty, I just *may* have managed to pull some strings with somewhere up here to get them done, I will find out tomorrow afternoon. I will let you know either way. Thanks again

so are turbos, so whats your point? you would be well advised to build in the facility to put down the extra power you are creating.

weird - I read that twice and I am certain it said elise! Elans are front wheel drive also, (well the modern elan is) so it should in thheory be a lot closer, as no doubt he will have the same high power standing launch issues you are going to have.

bigben has IHI'd his motor, and I think he is kicking about the 280-300bhp mark, and thats without out any internal mods (that I know of) You may still struggle against your mate, as your biggest problem will be putting the power down. while you are still merrily spinning your wheels off the line, mr elise will more than likely have fecked off up the strip :)

I cant beieve I was complaining about getting a quote for 600 quid on my r32!

cheers for the help lads

I am trying to get a couple of flexi pipes made up for my airconditioning system on the car, with not much success. Apparently it has to be a certain type of pipe and all the hydraulics places I have been to so far have not had it. Is there anyone in the North East that can help me out? Infact, is there anyone in the flipping country can help me out???! Help! its stopping me putting the front back on me car. help a fellow corrado owner, and I will give you a go in the car when its done ;-)

My mate has just bought one, and is averaging 14mpg!

you must drive like a woman lol

imagine what you would look like getting out of that car in a busy place. Dunno about you but I would feel like a right wanger

if I am not mistaken that is a 24v sump for definate, as it has the cut away for the oil probe in the bottom of it

LOL

go ben! I thought the 4wd was supposed to provide traction in adverse conditions lol

:lol: this one? LOL yes, thats the fella!

idea (in a baldrick fashion): Why dont you make a plastic short runner manifold. You can use a length of soil pipe for the body, and some sink drainage for the runners. It would be so easy too as you could use speed fittings lol

a delivery service. They require 200mph corrados to meet their deadlines

not a fan at all. Should be renamed 'Yellow headlights, Yay, Nay or Gay' :lol:

F**K that, a meat clever and a vice is the way forward.

where do you get these from? I need some to replace the plastic ones on mine as I am going to have to remove them. Speaking of which, how are they attached to the sill?

nice picture!

ok :lol: and on that note I will bow out of this discussion.

brings back memories...been a while since I tackled hardknott pass. Kirkstone pass is also a good one if you like that sort of thing