Supercharged
-
Content Count
16,478 -
Joined
-
Last visited
-
Days Won
2
Everything posted by Supercharged
-
Other thing to check is missing door membrane...
-
With Samco hoses you either need SAMCO's own pipe clips, proper Jubilee's or what I used - Mikalor which are very heavy duty! http://www.powerengineering.co.uk/mikalor/ Just be careful not to overtighten ones that go onto plastic pipes...
-
Womens Institute??
-
What actually is it?? - the mitchell repair manual??
-
R1-Jay, Is this on a Corrado?? No pollen filters fitted as standard...
-
LOL! 2.5 I heard...
-
*off to Tesco's...*
-
You're not doing a Henny and doing an engine swap in a car park are you??? Also - stick some rubber gloves over the driveshaft ends to stop grit getting in...
-
Should be ET33-35 for 4 stud... It will say on the wheels, you may have to give them a good clean to find it (may be on the inside)
-
Get the dipstick tube first and check the oil level!
-
what and where to buy Ignition leads???
Supercharged replied to PoorMansPorsche's topic in Engine Bay
What engine have yuo got?? -
Ah, nice one Chris - good to have you back with us!
-
It's just a Passat part so starts 357 It's also sided so the other side ends in 083
-
Saw a Red 16v J** UWL inmelton earlier...
-
Kev, the thermoswitch on the rad is only for the after run I think on a VR and is 2 speed, there is another one (midle one in the plastic housing) that controls the 3 speeds... I take it the fan controller you got matched the one you took off??
-
LOL - I can't argue with that!!
-
Yep, thats normal... just the way the circuit is designed...
-
Yep, it wipes once as you press the switch (weather you are switching on or off) I have a spare early switch if you need one...
-
Where can i get a manifold to fit twin 40 webers to my 16V?
Supercharged replied to wcrado's topic in Engine Bay
Stealth, drill a hole to reveal a screw to adjust the warm up regulator, this stops the car running lean high up in the rev range, the WUR mod is the best thing you can do to a Mk2 16V GTi! -
Yep, I noticed that they were doing that again - absolute bargain for what you get, that set will probably last me the rest of my life!
-
sharlie1982, so you have no dipped beam??? Check the fuses on the loom (should be near the battery) - even if they look ok you may want to re-seat them as they corrode under there, also tell us if ou have the 2 relay setup or not...
-
Yep, or you can unplug it at the fusebox end (yellow wire seperate from the rest of the loom)
-
sharlie1982, when you move the slider from hot to cold does it feel like it's connected to anything?? - it should be fairly stiff and you should here a flap moving across (if not the the cable may have snapped - a fiver from VW)
-
Yep, sounds like hall sender and just get the Bosch Silicone leads from Halfords..
-
1001 carpet cleaner - you can do a fairly good job in situ...