GrahamU

VSS is quite simple, PWR, GND and signal.

The signal is a 5v line supplied from the cluster, as the sensor turns the 5v is grounded causing the signal to be a 0 - 5v square wave

I'll check later for which pin is which

Just got the latest PVW which has a rallye fitted with a TT rack but theres no info on how it was done.

I seem to recall that Jay Renshaws may of had a mk4 rack but its a long thread to go through (but I will go through it gradually soon) so does anyone know if it can be done and whats needed?

Cheers

I have a late cluster in my early dash with the 20v engine,

tacho runs straight of the AGU ECU,

you need the VSS sensor in the gearbox to replace the cable,

You also need to run the second indicator feed

and there is a mod for the temp gauge, have a look here

http://forums.vwvortex.com/showthread.php?3078876-The-unofficial-Cluster-Swap-thread/page3&highlight=early+late+cluster

And I'm quite sure the size of tank doesn't matter, if its half full then its half full no matter what size it is, you just need to ignore the capacity printed on the dial

Tardis glue remover,

Does this come in a small pot but has a lot more in it than you think :)

What software do you use.

I have a choice of Solidworks or Catia but it would be good to know what others use.

Do you use it as a daily Tim?

If its not then drop the engine and box together, then you can do the lot without the car in the way

I've got a pair of 288s if your interested, I bought them thinking they were 280s but now running Brembo's

4x100 to 5x120... expensive

have you got a link to them

would not of thought of looking there, thought it was only vacuum operated

Just found an old 2009 thread asking the same, it would more than likely effect the rigidity of the body so not such a good idea

Was looking at an Audi A3 (mk1) with opening rears and wondered if this has been done to a Corrado?

did you fit the jetex or Kev.

how do you find it?

nice car, welcome to the forum

Is the wiring there?

To me, it sounds like someone has swapped the door card for a LHD to have just one switch,

If your lucky the wiring and connector will be tucked in behind the panel.

looks good

Change the cluster, its easy and will cost a lot less

there's a full write up on vortex on how to change it

You'll also need the electronic feed for a speedo to go into the ECU so if you change the cluster you will have the electronic speedo aswell

What ECU you going to use, the late cluster works with the OEM ECU

Golf looks good

is that a 3dr Cossie beside your Golf?

very very nice.

Like that alot

Oh you bugger! I was bidding on them too and you pipped me at the last second! They're my colour too! :bad-words: :thumbleft:

Me to

Welcome to the forum

but this mean nothing without pictures :)

They're pretty slow when accellerating from 1000-3500rpm, but after 3500 they take off and scream! They love being driven.

Life begins at 4K

good looking car, enjoy it

Just removed mine :( looks like I could do with a pair aswell

I used to think that but like I said, It wasn't a lecture just advice

However, I do work for a company who's primary business is building wire harnesses for all levels of motorsport including F1 and are now also moving into aero so I do have good knowledge on the subject. ;)