flusted
-
Content Count
2,755 -
Joined
Everything posted by flusted
-
southam in banbury ner oxford,they are excellent with 16vs My 1.8 made 162bhp after they tuned it up!
-
wont fit your engine! best bet is a rolling road set up to get the most out of your mods Stealth racing can get about 10bhp just from a tune up
-
see the tuning guide,it gives more top end at the sacrifice of low down
-
had exactly the same prob when i fitted my 2l,take off top rad hose and fill rad up first,squeezin all hoses,then run engine whilst revin up and down with cap off until i starts to boil over then turn off and re fill. This should work,i had lock in rad and heater matrix and it was a right pain ,i also ditched by pass valves but run car up with 1 pipe off to bleed the matrix Hope this helps
-
k-jet pumps can pump 12bar which is wot the lines are restricted to before they burst
-
mine didnt have cat,also the shape over axle was wrong and it knocked all the time
-
yours will have a cat for starters, i used a golf 16v system on my rado when i 1st got it but it was a crap fit
-
could we not start a thread dedicated to top tips? add it to wiki possibly
-
sounds like a top tip
-
Heres 1 of mine,bit shabby but respraying again soon
-
use a catch tank but re-route fumes back into engine,so tank catches the oil vapour
-
when i fitted my uprated loom it allowed both to be on when main beam was selected and bulbs were fine
-
easy! remove fan cowling 1st,then undo 2 10mm bolts on slam panel,undo pipes and it should tilt back enough to undo the plastic ducts either side? Then it should just lift out
-
I can appreciate thats a lot of work as i had nightmares fitting my bmw 1s
-
Thanks for the help guys,if you hear of any bits around let me know please
-
got a genuine cap coming now.but need the solenoid etc
-
Thanks! tryin 2 get someone to cut the plate out of a genuine audi at moment
-
havent really learnt anything yet? can i get a standard tt cap and cut it into car without the plate?
-
How do i go about fitting an audi tt petrol cap? is there a kit or can i just buy an original flap and fit that? Any help much appreciated
-
I had to remove the stops on a shitron arm to allow it to apply more pressure on the blade as the original arm they supplied was poo.
-
this will be a mk2 gti beam to go in a 2l 16v rado Thanks so far
-
As above,is the mk2 rear axle the same part as corrado? Thanks in advance
-
still want a standard rear 1 in carbon
-
Ive got a storm 1 aswell,no way near as good as lupos. I sold my lupos and regret it
-
Bought mine off a member on here and it was easy to fit. Have doubts daily of whether or not to keep it or ditch it but it goes with the whole look of the car.