corradium 10 Posted December 15, 2011 are still on line ---------- Post added at 05:24 PM ---------- Previous post was at 05:22 PM ---------- are you still on line Quote Share this post Link to post Share on other sites
Pat_McCrotch 0 Posted December 16, 2011 Monday: OSF lower door painted, blended and four dents taken out. Today: Putting my summer wheels into bags and one of them fell over onto said lower door. Putting a shallow dent in it. Not fecking happy! :mad: Hoping a dent devil person will be able to take it out. Quote Share this post Link to post Share on other sites
Critical_Mass 10 Posted December 16, 2011 are still on line ---------- Post added at 05:24 PM ---------- Previous post was at 05:22 PM ---------- are you still on line huh!? Quote Share this post Link to post Share on other sites
Macdaddy 10 Posted December 17, 2011 Replaced the speedo bulbs (two were missing!) Replaced heater control bulb I now have dashboard lights! Quote Share this post Link to post Share on other sites
Critical_Mass 10 Posted December 17, 2011 Replaced the speedo bulbs (two were missing!) Replaced heater control bulb I now have dashboard lights! Which bulbs did you use for the heater controls. Also early or late heater controls Quote Share this post Link to post Share on other sites
CazzaVR 0 Posted December 17, 2011 Got well and trully gritted by a gritting lorry on the way home :( Quote Share this post Link to post Share on other sites
Swompy 0 Posted December 17, 2011 Oh no :( I had that with my valver 3 gritter lorries in as many minuets, went over the bonnet and straight onto the windscreen :( Quote Share this post Link to post Share on other sites
CazzaVR 0 Posted December 17, 2011 Aye, I remember that! Will have a good look at it in the light tomorrow- hopefully no permanent damage. Quote Share this post Link to post Share on other sites
Swompy 0 Posted December 17, 2011 Finger crossed Quote Share this post Link to post Share on other sites
dalhalvaig 0 Posted December 18, 2011 Popped a flat blade wiper on the rear screen Quote Share this post Link to post Share on other sites
Macdaddy 10 Posted December 20, 2011 Replaced the led behind the heated seat switch! Quote Share this post Link to post Share on other sites
Nathan Harvey 10 Posted December 21, 2011 Mot smashed satis ! Quote Share this post Link to post Share on other sites
Macdaddy 10 Posted December 22, 2011 Degreased and cleaned both door shuts/hinges. Dont think they'd ever been done. Quote Share this post Link to post Share on other sites
Nathan Harvey 10 Posted December 23, 2011 Lupo gti wiper arms bought !! Quote Share this post Link to post Share on other sites
POMPEYCORRADO 0 Posted December 23, 2011 Done a double din conversion to my mk1 rado dash! ;) Quote Share this post Link to post Share on other sites
Macdaddy 10 Posted December 24, 2011 Done a double din conversion to my mk1 rado dash! ;) Ooh pics in another thread pls, thinking of doing this. Quote Share this post Link to post Share on other sites
Portent 0 Posted December 24, 2011 I drove from Surrey to Norfolk and back again to see my family. And changed the oil while at my brothers . Currently having a coffee break at South Mimms service station on the M25 on the way back. For most of the trip I got bored with the radio so just switched it off and listened to the engine. Thoroughly enjoyed the trip and it's good to give it a nice long run once in a while, especially on the lovely roads up there. I expect I will be washing her tomorrow :) Quote Share this post Link to post Share on other sites
CazzaVR 0 Posted December 27, 2011 Changed the driver's side handbrake cable (advisory from MOT). The plastic end piece decided to stay in the metal tube :roll: All fitted and OK now. Changed bulb in the instrument panel. Started to treat some rust under the rear of the sills. Looked like it might be pretty bad underneath, but once I'd stripped the underseal, I was pleasantlly surprised at the lack of rot. Only some surface stuff that I ground off with a drill. Primed it with antirust primer, ready for a coat of Rustoleum, followed by underseal and then paint 8) Quote Share this post Link to post Share on other sites
owen g60 10 Posted December 27, 2011 trial fitted some borbet A's... liking the look of them and the stance has changed considerably :) thoughts please Quote Share this post Link to post Share on other sites
daves16v 1 Posted December 27, 2011 Put down a small deposit on some alloys, to be collected in January. Quote Share this post Link to post Share on other sites
dalhalvaig 0 Posted December 27, 2011 Washed the C and RainX'd the front and rear screens. Plan to wax the body - Angelwax - and RainX anti fog the inside of the windows tomorrow morning. Have one coat of the stuff on and working really well. Had wondered if the windows didn't mist up because I keep it in a car port, but last week kept it on the street as our steep drive was frozen and still clear screens. Probably do my wife's Touran too. It's a diesel so takes a while to warm up and demist. Quote Share this post Link to post Share on other sites
tonedef 9 Posted December 27, 2011 Got the freshly powder coated rear beam back in with it's new bushes and brake lines. Feeling good as it seems like months since I've bolted anything on, it's always taking things off and adding to the shopping list! Quote Share this post Link to post Share on other sites
tony_ack 0 Posted December 28, 2011 Insured it. Taxed it. Drove it. Grinned. Quote Share this post Link to post Share on other sites
__Andy__ 0 Posted December 29, 2011 well yesterday... cleaned the c for the first time in 7 months, started on the button too! Quote Share this post Link to post Share on other sites
duncgti 10 Posted December 29, 2011 Spent the day changing indicator and washer stalks, putting doorcards back on after re attaching the plastic membrane properly, and checking that the abs and fans work correctly....they dont :) Quote Share this post Link to post Share on other sites
