Jump to content

Supercharged

Legacy Donators
  • Content Count

    16,478
  • Joined

  • Last visited

  • Days Won

    2

Everything posted by Supercharged

  1. I told Vince to stop smoking those cigars over peoples engines...
  2. Yep - all the cars with the 54mm Caliper Pistons use a 22.2mm master with a 9" servo unless ABS
  3. Not a clue - rear knock sensor?
  4. Welcome to the forum - VW sell them for less than £20!!!
  5. http://the-corrado.net/wiki/index.php/T ... bolt_sizes
  6. What car do you have? Yep - most corrado's prime as they have a fuel return system, they also have a run-on circuit to cool the fuel rail after the engine is switched off to prevent hot-start problems
  7. How are you bleeding it - easiest way is pressure bleeding?? Just fit the new slave and try it, then do the master - you can't just do the master and leave the original slave!
  8. It should have (and most likely still does have) a factory one... Have a read here - viewtopic.php?f=6&t=32852&hilit=reader+coil+wd40
  9. Ford dealer will sell this part seperatly (part from a 2.4 Galaxy VR6) viewtopic.php?f=14&t=66328&hilit=ford
  10. What year is it? - may be the reader coil if imobiliser fitted...
  11. Have you checke the inner wing? Yep, £500's worth of damage there...
  12. Welcome to the forum, we'll move to interior I think... Fuses deffo ok? I assume both sides not working at all - no clicks etc? Control unit is behind drivers side rear door card Anything else not working - worth looking at what else is on that circuit in the manual and checking them first...
  13. Cordless one is good - I have the older one but take a while to charge... for more heavy duty stuff I am now using a corded one - B&Q were doing a really good deal over xmas for £49 with dremel in a tool box with the flexible shaft and various accessories... they may still have some left!
  14. Fine to drive - will just re-learn it's adaptive settings - you may want to reset it again before going thru basic settings tho...
  15. Thats the outside air temp sender - should be mounted either on the brake cooling duct if fitted or the lower bumper grill
  16. http://www.vwspares.co.uk/corrado_brakes.php
  17. As, above - droplinks are only £15 each too so I think they quoted the wrong part completly!
  18. Price came up as of last week so they should be - theyre was one in the UK but not at MK - some other dealer...
  19. New G60 one is roughly £269 from VW with discount / GPC
  20. Deffo - as the clutch wears the bite will get higher, if it's low then it's a hydro issue... Is the slave still the original cast part? If so it will need changing anyway and if it's faulty then i would change the master too as it would have put more strain on this...
  21. Welcome to the forum - The standard mats have Corrado on them and are still available in black and grey but not beige IIRC, about £50 from VAG and altho not as thick as the Justmatz ones they are much better quality and should last another 10-15 years!
  22. The person who drove into you is liable - like any other accident!
  23. It's just a bulb that plugs in the back dude - you need to take the clocks out as a unit... It's a special bulb in a holder you need - 12v 1.2w Osram 509T - can get LED replacements now...
  24. Halfords do do them m ate - normally in a cabinet...
×
×
  • Create New...