daves16v

I believe it's a clip from the new Dukes of Hazzard movie.

purpley-corrado-dude, PM sent To those on this thread, thanks for the support. Much appreciated.

I did this on my valver but only to see what the effects were. Took my time round the bends tho..........very scary!

They are about 30p from the stealers.

Worth a go, what you got to lose? Nowt!

Yeah, it's turned into a 205 thread :lol:

Oh good, I sold my valver and bought a 16 year old 205 with 79k on the clock :)

Yes and yes.

Should take about 5 secs to rise fully.

Should that read 19/07/2005 ?

The glass is attached to a plastic slider that runs up and down a guide inside the door. It's at the lock end of the door. This becomes dettached and just sits at the bottom of the door and occasionally gets a grip on the glass and gets dragged back up the guide, if it falls again you can usually hear it hit bottom. This had already happened when I bought my Rado and made a loud clunk when the glass hit bottom. I glued it back on with plenty of super glue and the clunk almost disappeared. It's still attached 2.5 years on. Of course this may not solve your clunk but it's worth a look. I believe it's a common problem.

Dom, That looks really nice, keep it ON the road this time eh :lol:

Very nice mate.

dinkus, you got another VR! Nice Dom.

That is just SWEET!

Group session :shock: 8)

Stuck a grommit in there then sealed underneath. Painted the grommit of course.

h2vew, it actually looks ok but how does it ride??

kevhaywire, I mean very visibly taller like 1" and the tyre profiles were correct as was the pressures.

My 17's were taller than the 15's when put side to side :roll: :?

But if you've got 17's it will look lower as the wheels fill out the arches better.

I removed the wiper on my valver, it gives the rear a less cluttered, smoother look. Well that's why I did mine.

Not sure I like it but there's alot of work gone into the engine bay, just look at the detail.

Welcome to the forum. Are you keeping the cat tho :lol:

Cost me £22 for a new key cut and chip programmed when I first had my valver about 2.5 years ago. Local shop did it.